பீட் ரிம்மர் News Today : Breaking News, Live Updates & Top Stories | Vimarsana
Stay updated with breaking news from பீட் ரிம்மர். Get real-time updates on events, politics, business, and more. Visit us for reliable news and exclusive interviews.
Top News In பீட் ரிம்மர் Today - Breaking & Trending Today
Metric thread dimension wanted. | Model Engineer model-engineer.co.uk - get the latest breaking news, showbiz & celebrity photos, sport news & rumours, viral videos and top stories from model-engineer.co.uk Daily Mail and Mail on Sunday newspapers.
Silver Solder Stocks | Model Engineer model-engineer.co.uk - get the latest breaking news, showbiz & celebrity photos, sport news & rumours, viral videos and top stories from model-engineer.co.uk Daily Mail and Mail on Sunday newspapers.
Wall Chart | Model Engineer model-engineer.co.uk - get the latest breaking news, showbiz & celebrity photos, sport news & rumours, viral videos and top stories from model-engineer.co.uk Daily Mail and Mail on Sunday newspapers.
My lathe is turning tapers where I do not want tapers 34 of overhang in the 3 jaw chuck. At the far end it has 0.01 of runout on the DTI, not bad for a rusty old bar of 1 cold rolled. However the far end is 0.25mm forward and 1.11mm below where the tailstock wants it. This may or may not agree with the test spec. that came with the machine, they forget to define their units, could be Siamese. If I face down a bar leaving a tiny nub in the middle and then dent it with a hard center, I find the tailstock is fractionally low and forward. Unfortunately making everything worse not better. ....
I have a damaged gear that I need to reproduce. It is .750 or 19 mm diameter and has 14 teeth. This does not fit any Mod or DP formulae as far as I can see. The closest is 1.25Mod but that gives 20 mm diameter, it runs on a rack on my Hardinge clone, and I seem to recall from way back they tended to use weird gears. I seem to think I have two options, make a single point fly cutter and cut 14 teeth or make the blank 19mm diameter and cut 14 teeth 1.25 Mod.on it. The pattern is cut onto the shaft and has an unworn section so the diameter is as I stated. ....